Measurement And Instrumentation Paper 2020 B Tech Csjm University Kanpur

Share

Measurement And Instrumentation Paper 2020 B Tech Csjm University Kanpur

 

Department of Electronics and Communication Engineering,

Measurement and Instrumentation(ECE S-303)               

 UIET CSJM University KANPUR               

 Year 3″ year(2k18)   End Semester Examination                Total Maks: 40

 

PART(A) Q1-9 çarry 3 marks each and attempt any eight questions.

Q 1- What is drift in context of instrumentation and why it occurs. What is settling time?

Q 2- What do you understand by the term resolution of DAC.

 A 4-bit R-2R ladder type DAC having resistor value R=10kΩ and 2R=20kΩ using Vref of 10 V. Find

 (a) Resolution of the DAC and

 (b) Vo for digital input of 1101

Q 3- Explain construction and working of Unbonded strain gauge.

Q 4- Explain working and construction of Photomultiplier with a neat label diagram.

Q 5- Explain the working principle of successive approximation ADC with suitable block Diagram. 

Q 6- Give thermoelectric series and explain its significance in designing a thermocouple. And also classify thermocouple on industrial standards.

Q 7- Derive the balance condition of Kelvin double’s Bridge.

Q 8- A simple shunted ammeter using a basic meter movement with an internal resistance of 1800Ω and a full-scale deflection current of 100 pA is connected in a circuit and gives reading of 3.5 mA on it’s 5 mA scale. The reading is checked with a recently calibrated dc ammeter which gives a reading of 4.1 mA. The implication is that the ammeter has a faulty shunt on it’s 5mA range Calculate (a) The actual Value of faulty shunt, and (b) the current shunt for the 5mA rang.

Q 9- Explain working of piezoelectric microphone.

PART(B) Q10-14 carry 4 marks each and attempt any four.

Q10- Define/state the following.

(i) Law of intermediate metal
(ii) Thermoelectric lines 
(iii) Neutral Temperature
Q 11- Explain the dynamic behavior of galvanometer with suitable diagram and derivation of all the equation.
Q12- With a suitable block diagram explain the different components of Data Acquisition system.
Q 13- Draw a labeled diagram of LVDT and draw waveform of the voltage at the null voltage.
(a) Primary winding voltage
(b) secondary winding 1 voltage
(c) Secondary winding 2 voltage
(d) Final output voltage
and explain the following terms for LVDT.
(i) Null point repeatability
(ii) Single axis sensitivity
Q14- Give the types of writing mechanism in strip chart recorders.
 Explain the working of magnetic recorders with suitable labeled diagram

Share

Leave a Comment